Have you used both switches at once on the command line? "ghostexp -ignoreindex -corrupt"ĭepending on the arrangement of files on your original HD, you may find that you can't recover a significant number of files even though you have about 4GB of 'something' on the good ghost files. The stupid thing is that it dosen't let you get at least those files (the 70%)!Ĭan some one please help me out? Isn't anyway to repair/fix the corrupted image or a way to fool the GhostExp so it can read part of the imagefile?ĭaniele (if you have any solution please contact me urgently at: (Italy) But the problem is that at about 70% the ghost32 tells me that there is an inconcistency problem in the imagefile!! I've checked the Integrity of the imagefile with ghost32.exe and I can see the files scrolling. I was backing up my damaged HD with Norton Ghost 2003 when the HD finally crashed and the backup stoped at 93%!.I left the N.Ghost running 4 one day with no woulden't move from 93% so I switched off and found that on my Iomega External drive I have 3 files: I've quite an urgent problem.(I've tried the -ignoreindex and -corrupt options in ghost with no luck). "D:\Program Files\Symantec\Ghost\Ghost exp.exe" -corrupt When you use the -corrupt switch, Ghost Explorer ignores the corrupt area of the file and attempts to find the next file in the image. When Ghost Explorer encounters file corruption in an image file, it normally reports an error and stops. You may need to change the path to match the path on your computer. "D:\Program Files\Symantec\Ghost\Ghost exp.exe" -ignoreindex To use the switch, run GhostExp.exe from a DOS command line: The -IGNOREINDEX switch opens Ghost Explorer and tells Ghost Explorer to find the files by reading directly from the image file, rather than from the index file. Ghost includes an index file within each image file, and uses the index to find the other files that are in the image file. If you cannot extract the files, run Ghost Explorer from the command line with the switches -IGNOREINDEX and -CORRUPT. If there are files in the image that you must recover, try opening the image file with Ghost Explorer to extract the files needed. Also, do you mean Ghost 2003? I've never heard of a version 3 - not that there wasn't one, but the steps below are for current versions of Ghost. You don't have to restore the image through Ghost - just copy it to the hard disk before running the commands. gho files back to the hard disk first, and then running these steps? If the disk was created with the 'compressed' option, that might be the problem. What error messages do you get after the commands? Did they at least run for a while? Did you try copying the. Jake74 - I'm sure you didn't get anywhere in Ghost Explorer, but how far did you get 1) reading the index, or 2) ignoring the index and searching the image directly - as specified in the troubleshooting steps below? Note that you can't use both at the same time - a forced index read is a different operation than scanning to identify files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |